In addition, installation videos are available on our website to help provide assistance. For additional help, call our customer service at for installation, parts or technical questions. Sliding Shower Door Installation Instructions. Toggle navigation. Use a metal file to remove burrs and rough edges where you used the saw. Place the bottom track in position, right in the center of the ledge. Use masking tape to temporarily hold it in place. Next, prepare the wall jambs.
Use a level to ensure proper, plumb installation. Use masking tape to hold one jamb in place. Mark the screw holes on the wall with a pencil. Repeat the same process with the other door jamb. Install the Bottom Track and Wall Remove the taped wall jambs, and drill holes where you made your marks. Insert the wall anchor hardware provided into each hole you drilled.
Install the door jambs, and secure them to the anchors with the hardware provided. Use a screwdriver to tighten the screws. Remove the taped bottom track, and lay a bead of silicone caulk on the underside. Replace the bottom track, lining it up with the marks you made earlier. Install all necessary hardware. Measure and Install the Top Measure the distance between both walls at the top of the door frame.
The side with the small track for the sliding screen should face outwards. Screw the frame in place and add insulation. Use the same screws that you removed from the sides, top, and bottom of the old door frame. Otherwise, the doors may not fit properly. If there are sizeable gaps above and on the sides of the door frame, stuff a sheet or two of fiberglass insulation into these spaces. This will prevent your house from losing heat around the frame. Install the sliding glass panels and handle.
First, carefully clean all debris from the rails to get a good fit. Then, have a friend help you lift the first section of the sliding door. Set the bottom in place on the track in the door frame, and then press the top portion of the door in place too. Repeat with the second section of the sliding door. You can attach the lock clasp at this point as well. This is the small plastic bit that allows the lock on the door to hold it in place against the frame.
Re-attach the interior and exterior trim. Now that the door is securely in place, you can nail the interior and exterior trim back in place as well. Attach these to the same locations from which you removed them at the beginning of the process. Put up the screen. As the final step in installing your glass door, put in the screen. Snap it into place on both the top and bottom running tracks. Make sure that the screen slides open and shut without difficulty.
Include your email address to get a message when this question is answered. Begin and complete the installation while the weather is fair and warm. Helpful 0 Not Helpful 0. Old sliding glass doors can also be replaced with pre-hung French doors if you prefer. Sizes will tend to be a little different, but as long as you select French doors that are slightly smaller than the old door, it will be fairly easy to add more material to your frame to make it fit. Avoid getting doors that are too big, since it is much more difficult to try to make them smaller.
You Might Also Like How to. How to. Expert Interview. More References 9. About This Article. Co-authored by:. James Mansfield. Co-authors: 6. Updated: October 21, Categories: Door Types.
Article Summary X To install a glass door, start by appying waterprooof adhesive to the frame to protect it from water damage. Thanks to all authors for creating a page that has been read 49, times. Did this article help you? Cookies make wikiHow better. By continuing to use our site, you agree to our cookie policy.
0コメント